[Width 420mm]
size
- Top width 420mm x bottom width 420mm
- Height: 670mm
*Adjuster height is not taken into consideration.
Dimension details
Upper plate: width 420mm x depth 65mm x height 6mm
Flat steel: 6mm x 65mm
Adjuster thickness: 6mm
material
steel
Finishing
Baked paint
maximum weight
7kg (per leg)
Load capacity
100kg
*Based on our standards. Varies depending on type of top plate, installation method, etc.
remarks
- Also sold as 3 legs
- Accessories: 24 wood screws, 4 adjusters (40Φ)
- Hole diameter: 8mm = M6 screw compatible
-
Regarding hole positions (12 holes/1 leg)
Holes are drilled at positions divided into 5 equal parts from the holes at both ends (each 20 mm).
- The adjuster can be adjusted up to +5mm . The adjuster is used to adjust the unevenness of the floor, not to increase the height. Please note that stretching it more than 5mm may impair stability.
- There are 4 screw holes in total, 2 points evenly spaced 2 cm apart from both ends towards the center.
- Due to slight individual differences, there may be an error of approximately ±2mm in the stated size.
[Width 620mm]
size
- Upper width 620mm x lower width 620mm
- height: 670mm
*Adjuster height is not taken into account.
Dimension details
Upper plate: width 620mm x depth 65mm x height 6mm
Flat steel: 6mm x 65mm
Adjuster thickness: 6mm
material
steel
Finishing
Baked paint
maximum weight
8kg (per leg)
Load capacity
100kg
*Based on our standards. Varies depending on type of top plate, installation method, etc.
remarks
- Also sold as 3 legs
- Accessories: 24 wood screws, 4 adjusters (40Φ)
- Hole diameter: 8mm = M6 screw compatible
-
Regarding hole positions (12 holes/1 leg)
Holes are drilled at positions divided into 5 equal parts from the holes at both ends (each 20 mm).
- The adjuster can be adjusted up to +5mm . The adjuster is used to adjust the unevenness of the floor, not to increase the height. Please note that stretching it more than 5mm may impair stability.
- There are 4 screw holes in total, 2 points evenly spaced 2 cm apart from both ends towards the center.
- Due to slight individual differences, there may be an error of approximately ±2mm in the stated size.